K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
-
Align the propeller shaft with the alignment marks made previously.
4. Propeller shaft.
5. Retainers and bolts.
-
Tighten bolts to 20 Nm (15 ft. lbs.).
6. Axle shafts.
7. Lubricant to the rear axle as necessary.
Full-Floating Axle 11 Inch Ring Gear
-
Tool Required:
-
J 8614-01 Pinion Flange Holder and Remover
-
J 24384 Pinion Oil Seal Installer (Dana 11 inch ring gear axle).
-
The pinion oil seal and the pinion flange may be replaced with the carrier assembly installed in the vehicle.
REMOVE OR DISCONNECT
-
Raise the vehicle.
1. Propeller shaft.
Important: Scribe a line on the pinion stem, pinion nut and pinion flange to be used as an installation guide.
2. Nut using J 8614-01.