K 2500 Truck 4WD V8-5.7L VIN R (1996)
3. Front center bearing support to hanger.
-
Align the center bearing support 90° to the propeller shaft center line.
4. Bolt and washers.
5. Nuts.
-
Tighten nuts to 35 Nm (26 ft. lbs.). Maintain alignment.
6. Intermediate propeller shaft to front propeller shaft yoke.
-
Make sure reference marks are aligned.
-
Support intermediate propeller shaft.
7. Bolts and retainers.
-
Tighten:
-
Bolts to 35 Nm (26 ft. lbs.).
-
Nuts to 35 Nm (26 ft. lbs.).
8. Rear center bearing support to hanger.
-
Align the center bearing support 90° to both the front and intermediate propeller shaft centerlines.
9. Bolts and washers.
10. Nuts.