K 2500 Truck 4WD V8-6.5L DSL Turbo VIN F (1995)
Glow Plug: Service and Repair
Right Side
Glow Plugs (Right Side Turbo)
REMOVE OR DISCONNECT
1. Negative battery cable.
^
Raise the vehicle.
2. Right front tire.
3. Splash shield from the right front wheel well.
4. Lead wire from the glow plug in the #2 cylinder.
5. Lead wires for glow plugs in cylinders #4 and #6 at the harness connectors.
6. Heat shroud for the glow plug in the #4 cylinder.
7. Heat shroud for the #6 cylinder.
^
Slide the shrouds back far enough to allow access for unplugging the wires at the #4 and #6 glow plugs.
^
Use J 39083 to disconnect the glow plug wires.
8. Glow plugs from cylinders #2, #4, and #6.
9. Lead wire at the glow plug from cylinder #8 by reaching up from underneath the vehicle.
10. Glow plug from cylinder #8.
^
For easier access to cylinders #6 and #8, it may be necessary to remove the exhaust down pipe from turbocharger and muffler inlet pipe.
INSTALL OR CONNECT
1. Glow plug into cylinder #8.
Tighten
^
Glow plug to 17 Nm (13 lb. ft.).
