K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
Important: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
8. Remove the brake hose to caliper bolt from the brake caliper.
9. Remove the brake hose from the caliper.
10. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
11. Remove the caliper guide pin bolts (15 series pickups).
12. Remove the caliper guide pin bolts (25/35 series pickups).
13. Remove the brake caliper from the vehicle.
14. Inspect the caliper assembly.
Installation Procedure
Important: Use denatured alcohol to clean the outside surface of caliper boot before installing new brake pads.
