K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
10. Remove the park brake shoe from the actuator.
Installation Procedure
1. Install the park brake shoe to the actuator.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the park brake shoe retaining clip and retaining clip bolt.
Tighten the bolt to 3 Nm (25 ft. lbs.).
3. Install the park brake assembly and backing plate to the steering knuckle.
4. Install the wheel bearing.
5. Install the park brake cable to the park brake actuator lever.
6. Install the rear park brake bracket bolt.
Tighten the bolt to 61 Nm (45 ft. lbs.).
7. Install the park brake cable to the equalizer bar.
8. Adjust the park brake shoe.
