K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
18. Install the nuts retaining the fuel bleed valve and PCV oil separator bracket from the generator mounting bracket.
-
Tighten the bracket nuts to 25 Nm (18 ft. lbs.).
19. Install the power steering pump mounting bracket and bolts.
-
Tighten the power steering pump mounting bracket bolts to 46 Nm (34 ft. lbs.).
20. Install the water outlet tube.
21. Position the generator positive cable.
22. Install the generator positive cable in the clip on the engine front cover.
23. Install the generator positive cable and the retaining nut to the generator.
-
Tighten the generator positive cable nut to 9 Nm (80 inch lbs.).
24. Install the battery positive cable junction block bracket and bolt to the power steering pump.
-
Tighten the junction block bracket bolt to 9 Nm (80 inch lbs.).
25. Connect the generator electrical connector.
