K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
26. If replacing the upper valve rocker arm cover remove the grommets for the injector line fittings.
27. If replacing the upper valve rocker arm cover, remove the screws, PCV diaphragm, and spring.
28. Inspect the PCV diaphragm for damage.
29. Replace the PCV diaphragm if damaged is found.
30. Clean the sealer from the sealing surfaces on the upper valve rocker arm cover and the lower valve rocker arm cover.
31. Clean the upper valve rocker arm cover in suitable cleaning solvent.
32. Inspect for cracking and other damage on the upper valve rocker arm cover.
33. Replace the upper valve rocker arm cover if any damage.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. If removed, install the PCV diaphragm, spring, cover, and screws.
-
Tighten the PCV cover screws to 4 Nm (35 inch lbs.).