K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
6. Install the upper valve rocker arm cover bolts. Use the bolt tightening sequence. Bolts number 1 and 2 are used to position the valve rocker arm
cover.
6.1.
Tighten the bolts to 8 Nm (71 inch lbs.) in the sequence shown.
6.2.
Tighten the bolts again to 8 Nm (71 inch lbs.) in the sequence shown.
7. Install fuel injector lines.
-
Tighten the lines to 41 Nm (30 ft. lbs.).
8. Connect the PCV hose to the upper valve rocker arm cover.
9. Install the bolts (2) retaining the fuel injection control module wiring harness bracket.
-
Tighten the bolts to 10 Nm (89 inch lbs.).
10. Install the bolts (1) retaining the fuel injection control module wiring harness connectors.
-
Tighten the bolts to 21 Nm (15 ft. lbs.).