K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
9. Release the compressed air holding the valves in place.
10. Remove the J26999-20 (1) from the glow plug hole.
11. Continue to replace the valve stem seals on the remaining cylinders using the above procedures.
12. Install the fuel injector return pipe assembly.
Notice: Refer to Fastener Notice in Service Precautions.
13. Install the fuel injector return pipe to injector eye bolts and washers.
-
Tighten the fuel injector return pipe to injector eye bolts to 15 Nm (133 inch lbs.).
14. Install the fuel injector return pipe to cylinder head eye bolts and washers.
-
Tighten the fuel injector return pipe to cylinder head eye bolts to 15 Nm (133 inch lbs.).
15. Install the glow plug to the cylinder being serviced.
-
Tighten the glow plugs to 18 Nm (13 ft. lbs.).
16. Install the glow plug connector, Federal (2), California (1).