K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Remove the turbocharger.
2. Remove the intake air heater nut and wire terminal from the intake air heater.
3. Remove the following fuel pipes and wiring harnesses:
-
The main fuel pipes.
-
The fuel junction block.
-
The fuel hoses to the fuel injection control module (FICM) and the FICM wiring harness.
-
The fuel pipes to the left fuel rail.
4. Remove the turbocharger boost sensor bracket bolt.
5. Remove the turbocharger boost sensor with bracket.
6. Remove the intake air heater from the intake manifold tube, if replacing the tube.
7. Remove the intake manifold tube bolts and nuts.
8. Remove the intake manifold tube and the gaskets.
9. Discard the gaskets.
10. Clean the intake manifold tube in cleaning solvent and air dry.
Installation Procedure
