K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
5. Position the outlet heater hose.
6. Install the fuel filter mounting bolts.
7. Install the fuel injection control module.
8. Install the bolt (2) retaining the heater hose bracket to the generator bracket.
Tighten
Tighten the heater hose bracket bolt to 21 Nm (15 lb ft).
9. Remove the tape from the charged air cooler outlet duct to charge air cooler pipe opening and the intake manifold tube opening.
10. Position the hose on the pipe and the intake manifold tube.
The hose is marked ENG for the intake manifold tube end and DUCT for the pipe end.
11. Install the clamps and position as shown in order to allow the proper clearances.
Tighten
Tighten the hose clamps to 6 Nm (53 lb in).
