K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Install the sensor and a NEW metal gasket to the junction block.
If a crows foot is used to torque the sensor then special attention to the position of the crows foot in relation to the torque wrench Is required.
NOTE: Refer to Fastener Notice in Service Precautions.
2. If the crows foot is kept perpendicular (90 degrees) to the torque wrench during the entire tightening procedure, then the torque wrench can be set
to the listed torque specification.
Tighten
Tighten the sensor to 70 N.m (52 lb ft).
