K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
6. Lower the vehicle.
7. Install the fuel bundle bracket.
Tighten
Tighten the bundle bracket retaining nut to 16 N.m (12 lb ft).
8. Connect the chassis fuel pipes to the engine fuel pipes.
9. Purge air from the fuel system. Refer to Fuel Feed and Fuel Return Pipe Purge Procedure.
Fuel Hose/Pipes Replacement - Chassis - 3
REMOVAL PROCEDURE
IMPORTANT: Clean all the fuel pipe connections and the surrounding areas prior to disconnecting the pipes in order to avoid possible fuel system
contamination.
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Disconnect the fuel feed (1) and return pipes (2) from the fuel rail.
3. Disconnect the evaporative emission (EVAP) tube rear connection.
4. Cap the fuel rail pipes.
5. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
6. Remove the fuel hose/pipe bracket nut (5) from the bellhousing stud.
7. Remove the fuel hose/pipe bracket from the bellhousing stud.
8. Remove the fuel hose/pipe clip from the transfer case bracket, if equipped with four wheel drive (4WD).
9. Remove the fuel hose/pipe clips from the transmission brackets.
10. Remove the EVAP canister.
