K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
Seat Belt Retractor: Service and Repair
Rear Crew Cab
CAUTION: To avoid personal injury to the occupants of the vehicle, observe the following precautions:
^
More than one supplier's seat belts are used, therefore, install ONLY the seat belt components specified In the GM parts catalog.
^
To verify that the correct seat belt components were installed, insert the seat belt latch in the seat belt buckle. The latch must be fully
seated and be retained in the buckle until purposely released.
Removal Procedure
1. Remove the rear seat, if required.
2. Remove the rear quarter trim panel.
3. Remove the rear seat belt to body bolts.
4. Remove the rear seat belt retractor to body bolt (1).
5. Remove the retractor from the vehicle.
Installation Procedure
1. Install the retractor to the vehicle.
NOTE: Refer to Fastener Notice on page P-9 in Service Precautions.
2. Install the rear seat belt retractor to body bolt (1).
Tighten
Tighten the bolt to 53 N.m (39 lb ft).
3. Install the rear seat belt to body bolts.
