K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
4. Install the upper control arm bolts (4). Use the 15-series 2WD, the 15-series 4WD, and the 25/35-series 2WD where applicable.
5. Install the upper control arm nuts and the adjustment cams (2). Use the 15-series 2WD, the 15-series 4WD, and the 25/35-series 2WD where
applicable.
^
Tighten the nuts to 190 Nm (140 ft. lbs.).
6. Connect the upper control arm to the steering knuckle.
7. Install the wheel drive shaft.
8. Install the new nut to the upper ball joint stud.
^
Tighten the nut to 50 Nm (37 ft. lbs.).
9. Install the retaining bolts for the brake hose and wheel speed sensor brackets.
^
Tighten the bolts to 9 Nm (80 inch lbs.).
10. Install the tire and wheel.
11. Remove the safety stands.
12. Lower the vehicle.
13. Verify the wheel alignment.