K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
Parking Pawl: Service and Repair
Park Lock Pawl and Actuator Replacement
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan and filter.
3. Remove the park/neutral position switch.
4. Remove the manual shaft nut and the pin.
5. Remove the detent lever and the actuator assembly.
6. Remove the bolts and the parking pawl bracket.
7. Remove the parking pawl return spring.
8. Use the modified screw extractor in order to remove the plug.
9. Remove the parking pawl shaft retainer, the shaft and the pawl.
Important: If the manual shaft binds in the case during removal, file or sand the shaft in the area adjacent to the detent lever.
10. Remove the manual shaft.
11. Remove the manual shaft seal.
Installation Procedure