K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
Notice: Refer to Fastener Notice in Service Precautions.
11. Install the bolt securing cable support to the brace.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
12. Install the carpet and insulation around the driver's area.
13. Install the instrument panel knee bolster.
14. Raise the vehicle. Refer to Vehicle Lifting.
15. Ensure that the transmission manual shaft lever is in the mechanical park position.
16. Install the range selector cable end (2) to the transmission range selector lever ball stud (1).
17. The new front half (steering column end) of the cable will contain a new preinstalled E-clip.
18. Grasp the front half (cab end) of the transmission cable (1) in the left hand and the rear half (transmission end) of the transmission cable (2) in the
right hand.