K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
Pilot Bearing: Service and Repair
Pilot Bearing Replacement
^
Tools Required
-
J 43276 Clutch Pilot Bearing Remover
-
J 38836 Bushing Installer/Clutch Arbor
Removal Procedure
Notice: When using the J 43276 Clutch Pilot Bearing Remover always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench.
Do not allow the J 43276-1 tool body to rotate. Failing to do so will cause damage to the J 43276-1 tool body.
Important: The flywheel spacer (if applicable) must be removed prior to clutch pilot bearing removal.
1. Remove the clutch assembly.
2. Using J 43276 perform the following in order to remove the clutch pilot bearing:
2.1.
Install the J 43276-1 into the clutch pilot bearing.
2.2.
Using a wrench, secure the J 43276-1.
2.3.
Insert the J 43276-2 into the J 43276-1.
2.4.
Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
2.5.
Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
2.6.
Remove the J 43276-1 from the tool body.
3. Discard the old clutch pilot bearing.