K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
2.
Remove the center bearing support bracket from the kick-up crossmember using a cut-off wheel.
3.
After removal of the center bearing support bracket, grind the rough metal edges smooth that remain on the crossmember.
4.
Coat the exposed metal surfaces with frame coating using the information found in the applicable Service Manual and GM Refinish Material
Booklet # 4901M-D-2002 (English) or # 4901M-D-F2002 (French).
5.
Install the new propeller shaft. Refer to the Propeller Shaft Replacement - One Piece in the Propeller Shaft sub-section of SI2000 for installation
guidelines and yoke retainer tightening specifications.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
