K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Using J 44732 install the rear oil seal.
2. Install yoke.
3. Use the J 8614-01 in order to hold the yoke.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install a NEW yoke nut.
^
Tighten the yoke nut to 330 Nm (244 ft. lbs.).
5. Install the rear propeller shaft.
6. Check the transmission fluid level. Add if necessary.
7. Lower the vehicle.