K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Install the NEW motor encoder gasket to the transfer case.
2. Install the motor encoder to the transfer case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install motor encoder mounting bolts.
^
Tighten the bolts, in the sequence shown, to 20 Nm (15 ft. lbs.).
4. Install the motor encoder electrical connector. Ensure that the retention clips activate.
5. Install the front propeller shaft.
6. Install the transfer case shield.
7. Lower the vehicle.
