K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Install the new transfer case adapter seal.
Important: The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.
2. Install the transfer case adapter.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the transfer case adapter mounting bolts.
^
Tighten the transfer case adapter mounting bolts to 50 Nm (36 ft. lbs.).
Important: When installing the gasket to the adapter, make sure that the yellow printing on the gasket is facing toward the transfer case (away from
the transmission). The locating tab on the gasket should always be pointing to the top of the transfer case.
4. Install the new transfer case gasket.
5. Install the transfer case assembly.
6. Check the fluid level of the transfer case.
7. Lower the vehicle. Refer to Vehicle Lifting.
