K 2500 Truck 4WD V8-6.6L DSL Turbo VIN 1 (2002)
1. Install the J 43484 (2) to the 8092 (1).
2. Install the transfer case front output shaft seal on the 43484 (2).
3. Using the J 43484 (2) and the at 8092 (1), install the transfer case output seal.
4. Install the front propeller shaft.
5. Check the transfer case fluid level.
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
^
Tools Required
-
J 37668-A Output Shaft Seal Installer
-
J 45380 Transfer Case Rear Bushing Remover and Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the rear propeller shaft.
4. Remove the transfer case rear output shaft seal.
