K 3500 Truck 4WD V8-393 6.5L DSL Turbo VIN S (1995)
Clutch Assembly (Dual Mass Flywheel)
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Actuator cylinder.
-
Hydraulic tube and clips.
3. Inspection cover to clutch housing bolts.
4. Inspection cover from the clutch housing.
5. Transmission to clutch housing bolts.
6. Transmission from the clutch housing.
7. Clutch housing to the engine studs.
8. Clutch housing from the engine.
9. Spring, seat, and clutch fork.
10. Clutch fork inspection plug.
IMPORTANT:
-
Install J 5824-01 or a used clutch drive gear to support the clutch.
-
Mark the flywheel, clutch cover, and a pressure plate lug for alignment during installation.
11. Bolts and spring washers from clutch cover.
IMPORTANT: Loosen each bolt one turn at a time to avoid warping the clutch cover.
12. Cover assembly and driven plate.
-
Remove the clutch alignment tool
