K 3500 Truck 4WD V8-393 6.5L DSL Turbo VIN S (1995)
4. On all models, place joint in tool No. J 9522-3 or equivalent with lower yoke ear supported by 1 1/8 inch socket, Fig. 5, then press out cap. If cap
is not completely removed, insert spacer tool No. J 9522-5 or equivalent and continue to press, Fig. 6. If using a vice in place of special tool, use 1
1/8 inch socket to receive one cap and 5/8 inch socket to push opposite cap.
5. Rotate joint in tool or vice and press opposite cap out, then remove cross from yoke.
6. Inspect and clean retaining ring grooves.
7. Check cap bores for burrs and imperfections.
ASSEMBLY
1. Use finger to coat needle bearings with thin layer of grease. Do not fill cups completely or use excessive amounts. Over lubrication may damage
seals.
2. Put one bearing cap part way into one side of yoke, then insert cross into cap, Fig. 7.
3. Press cross and cap into yoke until cap is flush with yoke ear.