K 3500 Truck 4WD V8-454 7.4L (1994)
Throttle Position Sensor: Testing and Inspection
This check should be performed when TP sensor attaching parts have been replaced. A Tech 1 scan tool can be used to read the TP sensor output
voltage, or:
1. Connect digital voltmeter J 39200 or equivalent, from TP sensor connector terminal "B" (BLK wire) to terminal "C" (DK BLU wire). Jumpers for
terminal access can be made using terminals "1214836" and "12014837".
2. With ignition "ON," engine stopped, the TP sensor voltage should be less than .85 volt if more than 85 volt verify free throttle movement. If still
more than .85 volt, replace TP sensor.
3. Remove the voltmeter and jumpers, reconnect the TP sensor connector to the sensor.
