K 3500 Truck 4WD V8-454 7.4L VIN J SFI (1996)
In summary, whenever a vehicle subject to this campaign enters your vehicle inventory, or is in your dealership for service in the future, please take the
steps necessary to be sure the campaign correction has been made before selling or releasing the vehicle.
Service Procedure
1.
Raise vehicle.
2.
Remove exhaust crossover pipe.
3.
Remove flywheel inspection cover.
4.
Torque crankshaft pulley/balancer bolt (Figure 1, Item 1) to 149 Nm (110 Ft. Lb.) using two technicians, one holds flywheel).
5.
Install flywheel inspection cover.
6.
Install exhaust crossover.
7.
Lower vehicle.
8.
Install the GM Campaign Identification Label.
Campaign Identification Label/Claim Information
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in by the
by the customer for periodic servicing.
When installing the Campaign Identification Label, be sure to install the clear protective covering. Additional Campaign Identification Labels can be
obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m. to 4:30 p.m. EST). Ask for Item Number S-1015 when
ordering.
Apply the "Campaign Identification Label" only on a clean, dry surface.
Submit a Product Campaign Claim with the information indicated:
Refer to the General Motors Corporation Claims Processing Manual for details on Product Campaign Claim Submission.
