K 3500 Truck 4WD V8-5.7L VIN R (1998)
Wheel Fastener: Service and Repair
Front Suspension
REMOVAL PROCEDURE
^
Tools Required:
-
J 6627-A Wheel Stud Remover
1. Raise the vehicle. Support the vehicle with safety stands.
2. Remove the tire and the wheel.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
3. Remove the brake caliper.
4. Remove the rotor.
Important: Do not hammer on a wheel bolt.
5. Remove the hub bolt using the J 6627-A.
INSTALLATION PROCEDURE
1. Install the stud to the hub and bearing assembly.
2. Install four washers and the nut to the stud.
Tighten
2.1. Install the nut. Draw the stud in.
2.2. Remove the nut and the washers.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
