K 3500 Truck 4WD V8-5.7L VIN R (1998)
Heated Oxygen Sensor: Testing and Inspection
Heated Oxygen Sensor (HO2S) Testing
HO2S
The Heated Oxygen Sensors are mounted in the exhaust system where they can monitor the oxygen content of the exhaust gas stream. The oxygen
present in the exhaust gas reacts with the sensor to produce a voltage output. This voltage should constantly fluctuate from approximately 100 mV
(high oxygen content - lean mixture) to 900 mV (low oxygen content - rich mixture). The heated oxygen sensor voltage can be monitored with a scan
tool. By monitoring the voltage output of the oxygen sensor, the PCM calculates what fuel mixture command to give to the injectors (lean mixture -
low HO2S voltage = rich command, rich mixture - high HO2S voltage = lean command).
When the VCM detects an HO2S signal circuit that is low, the VCM will set the following DTCs:
^
DTC P0131 Bank 1 Sensor 1.
^
DTC P0151 Bank 2 Sensor 1.
^
DTC P0137 Bank 1 Sensor 2.
^
DTC P0157 Bank 2 Sensor 2.
When the VCM detects an HO2S signal circuit that is high, the VCM will set the following DTCs:
^
DTC P0132 Bank 1 Sensor 1.
^
DTC P0152 Bank 2 Sensor 1.
^
DTC P0138 Bank 1 Sensor 2.
^
DTC P0158 Bank 2 Sensor 2.
When the VCM detects no HO2S activity, the VCM will set the following DTCs:
^
DTC P0134 Bank 1 Sensor 1.
^
DTC P0154 Bank 2 Sensor 1.
^
DTC P0140 Bank 1 Sensor 2.
^
DTC P0160 Bank 2 Sensor 2.
NOTE: A fault in the heated oxygen sensor heater element or its ignition feed or ground will result in an increase in time to Closed Loop fuel
control. This may cause increased emissions, especially at start-up.
When the VCM detects a malfunction in the HO2S heater circuits, the following DTCs will set:
^
DTC P0135 Bank 1 Sensor 1 heater.
^
DTC P0155 Bank 2 Sensor 1 heater.
^
DTC P0141 Bank 1 Sensor 2 heater.
^
DTC P0161 Bank 2 Sensor 2 heater.
The VCM also has the ability to detect HO2S response, switching, transition time, and incorrect ratio voltage problems. If a HO2S response switching,
transition time, or ratio problem is detected, the VCM will store a DTC that indicates degraded HO2S performance.
HO2S Bank 1 Sensor 1 & Bank 2 Sensor 1
