K 3500 Truck 4WD V8-5.7L VIN R (1998)
6. Apply a few drops of clean engine oil to the male connector tube ends.
7. Connect the quick-connect fittings at the fuel feed and pipe near the in-line filter and at the fuel sender assembly. Refer to Quick Connect Fitting(s)
Service (Metal Collar).
8. Install the fuel tank and attaching hardware if the tank was removed.
9. Tighten the fuel filler cap.
10. Connect the negative battery cable.
11. Check for fuel leaks.
11.1.
Turn the ignition switch to the ON position for 2 seconds.
11.2.
Turn the ignition switch to the OFF position for 10 seconds.
11.3.
Again, turn the ignition switch to the ON position.
11.4.
Check for fuel leaks.
