K 3500 Truck 4WD V8-5.7L VIN R (1998)
3. If the park/neutral position switch did not slide off the manual shaft, file the outer edge of the manual shaft in order to remove any burrs.
4. Install the switch to the transmission manual shaft by aligning the switch hub flats with the manual shaft flats.
5. Slide the switch onto the transmission manual shaft until the switch mounting bracket contacts the mounting bosses on the transmission.
6. Install the switch to the transmission with two bolts.
-
Tighten the bolts securing the switch to 28 Nm (21 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Remove the J41364-A from the switch.
8. Install the wiring harness connectors to the switch.
9. Install the transmission control lever to the manual shaft with the nut.
-
Tighten the control lever nut to 28 Nm (21 ft. lbs.).
10. Lower the vehicle.
11. Connect the negative battery cable.
12. Inspect the switch for proper operation. The engine must start in the Park or Neutral positions only. If adjustment is required, loosen the switch
retaining bolts and rotate the switch slightly, then tighten the bolts and check the switch for proper operation.
