K 3500 Truck 4WD V8-6.0L VIN U (2002)
1. Install the intermediate cable.
2. Connect the intermediate cable to the front cable.
3. Connect the equalizer to the rear park brake cables.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the nut to the threaded end of the intermediate cable.
Tighten the nut to 3.5 Nm (31 inch lbs.).
5. Remove the safety stands.
6. Lower the vehicle.
7. Adjust the park brake system.
Park Brake Cable Mounting Bracket Replacement
Park Brake Cable Mounting Bracket Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Release the tension on the cables by loosening the nut at the equalizer.
4. Disconnect the rear cables from the equalizer.
5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
