K 3500 Truck 4WD V8-6.0L VIN U (2002)
6. Remove the cable support bracket nuts.
7. Remove the cable support bracket.
Installation Procedure
1. Install the cable support bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cable support bracket nuts.
Tighten the support bracket nuts to 85 Nm (64 ft. lbs.).
3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
4. Connect the rear cables to the equalizer.
5. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
6. Remove the safety stands.
7. Lower the vehicle.
Park Brake Cable Equalizer Replacement
Park Brake Cable Equalizer Replacement
