K 3500 Truck 4WD V8-6.0L VIN U (2002)
1. Install the TP sensor O-ring seal (7).
2. Install the TP sensor into the throttle body with the throttle valve in the closed position. Make sure the TP sensor lever lines up with the TP sensor
drive lever on the throttle shaft.
NOTE: Refer to the Fastener Notice in Service Precautions.
3. Install the TP sensor screws (5).
Tighten
Tighten the screws to 2 N.m (18 lb in).
4. Connect the TP sensor electrical connector.
5. Install the generator.
