chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Engine - Knocking or Lifter Noise|Page 303 > < Brakes - ABS Lamp ON/DTC's C0265/C0201/U1041 Set|Page 297
Page 1
background image

Oil Pick Up/Strainer: All Technical Service Bulletins
Engine - Knocking or Lifter Noise

File In Section: 06 - Engine/Propulsion System 

Bulletin No.: 02-06-01-038

Date: December, 2002

TECHNICAL

Subject: 
Engine Knock or Lifter Noise (Replace 0-Ring)

Models: 
2001-2002 Chevrolet Camaro
2001-2003 Chevrolet Corvette
2001-2002 Pontiac Firebird
2002-2003 Cadillac Escalade, Escalade EXT
2000-2003 Chevrolet Suburban, Tahoe
2001-2003 Chevrolet Silverado
2002-2003 Chevrolet Avalanche
2000-2003 GMC Yukon, Yukon XL
2001-2003 GMC Sierra
with 4.8L, 5.3L, 5.7L or 6.0L V8 Engine (VINs V, T, Z, G, S, N, U - RPOs LR4, LM7, L59, LS1, LS6, LQ9, LQ4)

Condition

Some customers may comment on an engine tick noise. The distinguishing characteristic of this condition is that it likely will have been present since
new, and is typically noticed within the first 161-322 km (100-200 mi). The noise may often be diagnosed as a collapsed lifter. Additionally, the noise
may be present at cold start and appear to diminish and then return as the engine warms to operating temperature. This noise is different from other
noises that may begin to occur at 3219-4828 km (2000-3000 mi).

Cause

The 0-ring seal between the oil pump screen and the oil pump may be cut, causing aeration of the oil.

Correction

Inspect the 0-ring seal and replace as necessary. Use the applicable part number listed below. Refer to the Engine Mechanical sub-section of the
appropriate Service Manual.

Parts Information

Parts are currently available from GMSP0.

Warranty Information

For vehicles repaired under warranty, use the table shown.

Engine - Knocking or Lifter Noise|Page 303 > < Brakes - ABS Lamp ON/DTC's C0265/C0201/U1041 Set|Page 297