K 3500 Truck 4WD V8-8.1L VIN G (2002)
Installation Procedure
1. Use the following procedure in order to install the fender to the vehicle:
1. Position the locating notch in the fender to the vehicle.
2. Rotate the fender up 90 degrees.
3. Slide the fender under the retainers.
4. Rotate the fender down 90 degrees into the body position.
2. Install the rear retaining screws.
3. Install the fender to the rear pillar retaining bolts through the tail lamp opening.
4. Install the tail lamp assembly. Refer to Tail/Turn Signal Lamp Replacement (Except Stepside) Tail/Turn Signal Lamp Replacement (Stepside) .
5. Install the fender step bolts.
6. Install the step pad.
7. Install the front filler bolts.
8. Install the lower fender brace rods bolts.
9. Install the top fender molding.
10. Install the top molding rear push-pin retainer.
