K 3500 Truck 4WD V8-8.1L VIN G (2002)
7. Install the quarter shaft shield.
8. Install the quarter shaft shield nut and the bolt.
Tighten the quarter shaft shield nut and the bolt to 25 Nm (18 ft. lbs.).
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. With the engine OFF gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds then repeat steps 6, 7, and 8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
