K 3500 Truck 4WD V8-8.1L VIN G (2002)
Brake Rotor/Disc: Service and Repair
Disc Brake Backing Plate Replacement
Rear
Disc Brake Backing Plate Replacement Rear (25/35 Series)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly.
4. Relieve the tension from the park brake cables by loosening the nut at the equalizer.
5. Remove the rear park brake cable from the park brake actuator lever.
6. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
7. Remove the rotor.
8. Remove the axle shaft.
9. Remove the park brake shoe.
10. Remove the backing plate nets.
11. Remove the backing plate from the axle housing flange.
Installation Procedure
1. Install the backing plate to the axle housing flange.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the backing plate nuts.
Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
3. Install the park brake shoe.
4. Install the axle shaft.