K 3500 Truck 4WD V8-8.1L VIN G (2002)
Important: The oil pan must be installed within 5 minutes of the sealer being applied or the sealer will begin to cure, causing an inadequate seal.
1. Apply sealant GM U.S. P/N 12346286, Canada P/N 10953472, or equivalent to the sides of the front (1) and rear (2) crankshaft bearing caps, on
both the left and right sides (4 locations total).
2. Install a NEW oil pan gasket (2) into the oil pan groove, if required.
3. Install the oil pan (1).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the oil pan bolts.
4.1.
Tighten the oil pan bolts in sequence a first pass to 10 Nm (89 inch lbs.).
4.2.
Tighten the oil pan bolts in sequence a final pass to 25 Nm (18 ft. lbs.).
