K 3500 Truck 4WD V8-8.1L VIN G (2002)
7. Install the cable to the steering column bracket. Ensure the tangs fully seat (snap) into the steering column bracket.
8. Install the retainer (2) securing the cable to the steering column.
9. Install the cable end (1) to the steering column ball stud.
10. Install the cable to the support.
Notice: Refer to Fastener Notice in Service Precautions.
11. Install the bolt securing the cable support to the brace.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
12. Install the carpet and insulation around the driver's area.
13. Install the instrument panel knee bolster.
14. Raise the vehicle.
