K 3500 Truck 4WD V8-8.1L VIN G (2002)
12. Position the inboard end (tripot end) of the halfshaft assembly into the base of J 36652.
13. Install the top half of J36652.
14. Align the swage ring (2) and the swage ring clamp.
15. Insert the bolts.
^
Hand tighten the bolts in J 36652 until the bolts are snug.
Important: Align the following during this procedure:
^
The tripot seal (3)
^
The housing (1)
^
The swage ring (2)
^
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of J 36652 touch the bottom half of J
36652.
16. Loosen the bolts and remove the halfshaft assembly from J 36652.
17. Remove the convolute retainer tool from the seal.
