K 3500 Truck 4WD V8-8.1L VIN G (2002)
Fluid - Transfer Case: Service and Repair
NVG 261-NP2 (Two Speed Manual)
Transfer Case Fluid Replacement
Removal Procedure
Important: When performing the following service procedures, use only hand tools in order to remove and install the fill or drain plugs. Always start
the plugs by hand in order to prevent cross threading.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the transfer case fill plug.
4. Remove the transfer case drain plug.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
Important: If the drain or fill plug have to be replaced, use only aluminum replacement drain plugs. Steel plugs will react with the magnesium of the
transfer case.
