K 3500 Truck 4WD V8-8.1L VIN G (2002)
5. Inspect the rear output shaft bushing for scoring or wear.
6. Remove the rear output shaft bushing if required, using the J 45380.
^
Install the finger section of the J 45380 in front of the bushing.
^
Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
^
Using a wrench on the forcing screw, remove the rear output shaft bushing.
Installation Procedure
1. Install a NEW rear output shaft bushing, if required, using the J45380.
^
Install the bushing or the finger section of the J 45380.
^
Install the finger section to the main body of the J 45380.
^
Position the bushing and tool to the case.
^
Using a hammer and the J 45380, install the bushing.
2. Position the rear output shaft seal in the transfer case.
3. Using the J 37668-A, install the front output shaft in the transfer case.
4. Install the rear propeller shaft.
5. Check the fluid level.
6. Install the transfer case shield to the cross member.
7. Lower the vehicle.
