K 3500 Truck 4WD V8-8.1L VIN G (2002)
Seals and Gaskets: Service and Repair
NVG 263-NP1 (Selectable)
Transfer Case Output Shaft Seal Replacement- Front
Transfer Case Output Shaft Seal Replacement- Front
^
Tools Required
-
J 8092 Universal Handle
-
J 43484 Front Output Shaft Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield from the crossmember (if equipped).
3. Remove the front propeller shaft from the vehicle.
4. Insert a flat-tipped screwdriver in the inner race.
5. Pry the inner race back.
6. Insert a small pry bar in the inner race.
Important: When performing the following service procedure, the outer part of the seal will slightly move out of the transfer case with the inner part
seal.
7. Pry the inner part of the seal from the outer seal body.
