K Tahoe 4WD V8-4.8L VIN V (2000)
Compact Disc Player (CD): Description and Operation
In order to operate the compact disc (CD) player, perform the following steps:
^
Press the PWR knob to turn the system ON.
^
Insert a disk part way into the slot with the label side up.
^
Wait a few seconds.
^
The disk should then begin to play, and a CD symbol will appear in the display.
^
If the disc is very hot, or if you're driving on a very rough road, a disc may come out or just not play. When the disc player is too hot to play a disc,
ERR will appear on the display.
When the disc player returns to normal temperature, the disc should play again.
If the disc still will not play, check for the following possible problems:
^
An upside down disc
^
A dirty, scratched, or wet disc
^
Too much moisture in the air
If there is too much moisture in the air, wait about one hour and try again.
^
The vehicle is operating on a very rough road.
Previous Track (PREV)
Press SEEK down or PREV in order to search for the previous track.
Audio is muted during SEEK
Random Playback (RDM)
The random playback feature allows the tracks on the compact disc play in random order rather than in sequential order.
In order to stop the random playback feature, press RDM.
During random playback, a RANDOM indicator appears in the display.
Next Selection (NEXT)
Press SEEK up or NEXT in order to search for the next selection. Hold the push-button or press the push-button more than once in order to advance
the disc further. Audio is also muted during NEXT.
Reverse (REV)
Press and hold the REV button in order to return rapidly to a favorite passage. This is an audible search at a high rate of speed.
Release REV in order to resume play at a normal speed.
Forward (FWD)
Press and hold FWD in order to advance quickly within a track. This is an audible search at a high rate of speed.
Release FWD in order to resume play at normal speed.
Recall (RECALL)
^
Press RECALL in order to see what track Is playing.
^
Press RECALL again within 5 seconds in order to view the elapsed time.
The elapsed time is displayed in minutes and seconds.
^
Press RECALL again in order to return to the time of day.
^
The track number appears when a new track starts to play.
Band Switching (AM/FM)
While a compact disc is playing, press the AM/FM push button in order to cancel the CD player and turn ON the radio.
The CD symbol will still be displayed, but the word CD will be replaced by FM1, FM2, or AM in the display.
If the radio is turned OFF during compact disc playback, the disc stays in the player. The CD will resume playing at the point where the CD stopped.
Compact Disc/Auxiliary (CD/AUX)
The CD/AUX push-button switches between CD play mode and radio operation.
When you insert a CD, the CD plays until you press the AM/FM push-button.
