K Tahoe 4WD V8-4.8L VIN V (2000)
3. Remove the window run channel bolts.
4. Remove the front and the rear window run channels from the door.
Installation Procedure
1. Install the front and the rear window run channels to the door.
Notice: Refer to Fastener Notice.
2. Install the front and the rear window run channel bolts.
1. Tighten the front bolt to 9 N.m (80 lb in).
2. Tighten the rear bolt to 9 N.m (80 lb in).
3. Install the window glass weatherstrip.
4. Install the window.
Door Window Weatherstrip
Front Side Door Window Weatherstrip Replacement
Removal Procedure
1. Remove the door trim panel.
2. Remove the water deflector.
3. Remove the window.
4. Remove the screws.
5. Pull the weatherstrip from the following locations:
*
The front of the glass run channel
*
The top of the window frame flange
*
The rear of the glass run channel