K Tahoe 4WD V8-4.8L VIN V (2000)
1. Remove all related panels and components.
2. Remove any excess sealer surrounding the existing hinge and scribe the location of the hinge on the hinge pillar.
3. Lightly hand-sand the existing hinge with 100 grit or finer sandpaper in order to locate the 4 welds that attach the hinge to the pillar.
Important: It is critical to punch the center of the weld so that as much of the weld as possible is removed during the drilling.
4. Center punch each of the four weld marks on the original hinge.
Important: Do not drill into the door (1).
5. Drill through the hinge (2), at each punch location. Use a 13 mm (1/2 in) rotabroach hole saw (3) or equivalent.
6. Remove the hinge. If necessary, use a chisel in order to separate the hinge from the door.
7. Remove all of the remaining welds from the door surface in order to ensure a flush fit of the service hinge.
Installation Procedure
1. Repair any damage done to the door during the drilling or the removal of the hinge.
2. Clean and prepare the backing plate mounting surfaces in order to ensure a flush fit of the backing plate.
3. Position the service hinge within the scribe marks on the door.
4. Center punch each hole location on the door according to the service hinge.
5. Drill a 3 mm (1/8 in) pilot hole at each center punch location.
Important: Drill must be exact size.
6. Drill an 11.5 mm (29/64 in) hole at the pilot locations for the studs.
7. Clean and prepare all of the bare metal surfaces.
Important: Prior to refinishing, refer to the publication GM 4901M-D-2000 GM Approved Refinish Materials for recommended products. Do not
