K Tahoe 4WD V8-4.8L VIN V (2000)
Tighten the trim panel armrest screws to 2 N.m (18 lb in).
3. Install the door handle bezel.
Rear Side Door Trim Panel Replacement (Tahoe/Yukon)
Rear Side Door Trim Panel Replacement (Tahoe/Yukon)
Removal Procedure
1. Remove the door handle bezel.
2. Remove the window regulator handle, if equipped.
3. Remove the trim panel screws.
4. Slide the trim panel up in order to remove the trim panel from the door.
5. Disconnect the electrical connectors, if necessary.
Installation Procedure
1. Connect the electrical connectors, if necessary.
2. Align the retainers with the holes in the door.
3. Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
4. Install the window regulator handle, as necessary.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the trim panel screws.
Tighten the trim panel screws to 2 N.m (18 lb in).
6. Install the door handle bezel.
Trim Panel Replacement - Side Access (Left Hand)
REMOVAL PROCEDURE
