K Tahoe 4WD V8-4.8L VIN V (2000)
6. Install the caliper mounting bracket to the backing plate assembly (25 series).
7. Perform the following procedure before installing the caliper mounting bracket bolts.
7.1.
Remove all traces of the original adhesive patch.
7.2.
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
7.3.
Apply Threadlocker GM P/N 12345493 or Red LOCTITE(TM) #272 to the threads of the bolt.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the caliper mounting bracket bolts to the steering knuckle.
^
Tighten the brake caliper mounting bracket to 200 N.m (148 lb ft) (15 series).
^
Tighten the brake caliper mounting bracket to 165 N.m (122 lb ft) (25 series).
9. Install the caliper. Refer to Brake Caliper Replacement - Rear.
10. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
11. Remove the safety stands.
12. Lower the vehicle.
13. Refill the master cylinder to the proper level with fresh brake fluid.
14. Pump the brake pedal slowly and firmly in order to seat the brake pads.
15. Burnish the brakes as needed. Refer to Burnishing Pads and Rotors.
