K Tahoe 4WD V8-4.8L VIN V (2000)
7. Remove the 2 bolts (4) securing the BPMV mounting bracket (3) to the BPMV (1).
8. Disconnect the 2 way ABS pump motor connector.
9. Remove the four T-25 TORX® bolts from the EBCM (2).
Important:
-
Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
-
Do not reuse the EBCM mounting bolts. Always install NEW bolts.
10. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
11. Clean the EBCM to BPMV mounting surfaces with a clean cloth.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants,
or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may
damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Important: Do not reuse the old mounting bolts. Always install NEW bolts with the new BPMV.
1. Install the EBCM (2) onto the BPMV (1).
2. Install the four EBCM bolts. Tighten the four bolts to 5 Nm (39 lb in) in an X-pattern.
3. Connect the 2 way ABS pump motor connector to the EBCM.
4. Install the BPMV (1) to BPMV bracket (3).
5. Install the BPMV to bracket retaining bolts (4). Tighten the bolts to 9 Nm (7 lb ft).
